MSR MSR145W2D, User Manual

Page: 18 / 27

MSR Electronics GmbH • Mettlenstrasse 6 • CH-8472 Seuzach, Switzerland
Phone +41 52 316 25 55 • info@msr.ch • www.msr.ch • www.datalogger.shop
© MSR Electronics GmbH, 2020-03-12. All rights reserved. 18
Appendix A3: Display WiFi connection
To establish the WiFi connection please proceed as follows:

Connect the MSR145W2D to the WiFi network (see Appendix A2)

For an initial test of the WiFi connection, the WiFi of the logger connected to the cable
must be activated using the "Activating status" tab. To check, the status of the WLAN
connection of the logger must then be "Read".

The following indicators for the WiFi status ("State") are relevant:
State Meaning
Inactive WiFi module is switched off.
Scanning …
Searching for a WiFi network (SSID). -> If necessary, please check
whether the relevant WiFi network is switched on.
Joined XX
1
Joined a WiFi network. SSID and password are correct.
Connected XX
1
: Connected to WiFi, IP address received.
Ready XX
1
:
The MSR145W2D is successfully connected to the destination, e.g.
the MSR SmartCloud or local application and data will be
transmitted.
Retry …:
The logger's WiFi module could not establish a connection and was
automatically switched off. A new connection attempt will be initiated.
Get version: Version number of the WiFi module will be queried.
1
XX: RSSI value (indicator for the reception field strength; > -70 = good, < -80 = bad)