4-7
BIOS Setup
IDE HDD Auto-Detection
Press Enter to allow BIOS to auto-detect the type of the HDDs.
IDE Channel 0 M aster
Press PgUp/<+> or PgDn/<-> to select Manual, None or Auto type. Note that the
specifications of your drive must match with the drive table. The hard disk will
not work properly if you enter improper information for this category. If your
hard disk drive type is not matched or listed, you can use Manual to define your
own drive type manually.
If you select Manual, related information is asked to be entered to the following
items. Enter the information directly from the keyboard. This information should
be provided in the documentation from your hard disk vendor or the system
manufacturer.
Access Mode
The settings are CHS, LBA, Large, Auto.
Capacity
The formatted size of the storage device.
Cylinder
Number of cylinders.
Head
Number of heads.
Precomp
Write precompensation.
Landing Zone
Cylinder location of the landing zone.
Sector
Number of sectors.
Halt On
The setting determines whether the system will stop if an error is detected at boot.
When the system stops for the errors preset, it will halt on for 15 seconds and then
automatically resume its operation. Available options are:
[All Errors]
The system stops when any error is detected.
[No Errors]
The system doesn
’
t stop for any detected error.
[All, But Keyboard]
The system doesn
’
t stop for a keyboard error.
Base / Extended / Total M emory
The three items show the memory status of your system (read only).
Summary of Contents for 945-E - Hetis - 0 MB RAM
Page 1: ...Hetis 900 Series MS 6439 V1 X Barebone G52 64391X1 ...
Page 6: ...vi WEEE Statement ...
Page 7: ...vii ...
Page 8: ...viii ...
