English
Operation manual
19
4.3. While holding the pneumatic clamp from turning, use the lower pneumatic clamp height
adjustment wheel to set the pneumatic clamp pushers coaxially with the lower shock absorber
mount (prism) (see Fig. 21).
Figure 21. Adjusting the height of the lower pneumatic clamp
4.4. «Clamp» the pneumatic clamp and position the shock absorber along the middle of the
pneumatic clamp in the same way as with the upper clamp, see pos. 3.2.
4.5. In addition, tighten the pushers to the shock absorber mount (prism), and then tighten the
lock nuts.
4.6. By turning the height adjustment wheel of the lower pneumatic clamp counterclockwise, set
the working height of the shock absorber. Usually it is 3 - 5 turns, but at least 2 turns.
4.7. Fix the height adjustment stopper and the lower clamp stopper.
5. Place and clamp the temperature sensor on the shock absorber (Fig. 22).
6. Close the test chamber door.
