Version 3.4
22
NC-217
Operating manual
Table 7 – CL № 1. Visual inspection of the Product
To be done
Routine
Man-hours
per 1 Product
Visually examine the
Product
1 check exterior condition of the Product; mechanical
damage, paint defects must be absent; marking plates
shall be present; legends are to be read easily;
2 clean up the Product surfaces with clean cloth;
3 remove severe contamination, parts of corrosion, oil
spots from the metal surfaces – using soap suds, avoid-
ing its penetration inside the Product; then clean dry all
surfaces by clean cloth and dry them up;
4 if varnish paint coating is damaged, polish it with sand
paper, then clean with alcohol-soaked cloth, cover with
varnish and dry up
1 person
5 minutes
Check reliability of ca-
ble and grounding bus
connection to the Prod-
uct
1 make sure that connectors and attaching screws are
fastened tight; provide further fastening if needed;
2 check the cable integrity (mechanical damage shall be
absent) within visibility
1 person
5 minutes
Table 8 – CL № 2. Operation test of the Product
To be done
Routine
Man-hours
per 1 Product
Check the Product’s op-
eration
1 switch the Product’s power on;
2 make sure that main power is available by lighting of
Power
LED located on the Product’s casing
1 person
5 minutes
