PAGE 20 — MP1 SERIES MASONRY SAW • OPERATION AND PARTS MANUAL — REV. #2 (10/12/17)
SET-UP
CONNECTING THE POWER
1. Place the power
ON/OFF
switch (Figure 11) in the
OFF
position (down).
Figure 10. Power ON/OFF Switch
2. Connect an extension cord of adequate current carrying
capacity to the power plug on the electric motor.
3.
MAKE CERTAIN
that the correct size extension cord
is used. Undersized wires will burn out motors. Use
Table 4 to determine the correct extension cord size.
Table 4. Extension Cord Sizes
MOTOR
VOLTAGE
VAC
50 ft
(15. 2 m)
Long
75 ft
(22.9 m)
Long
100 ft
(30.5 m)
Long
1.5 HP
115
NO. 10
NO. 10
NO. 8
1.5 HP
230
NO. 14
NO. 14
NO. 14
2.0 HP
115
NO. 10
NO. 8
NO. 6
2.0 HP
230
NO. 12
NO. 12
NO. 12
DANGER
NEVER
grab or touch a live
power cord with wet hands, the
possibility exists of electrical shock,
electrocution, and even death!
NEVER
use a damaged or worn
extension cable when connecting
to a power source. Defective cables may cause damage
to the saw’s electric motor or electrical shock.
ALWAYS
use a grounded (3-wire) extension cord
and
MAKE CERTAIN
that the motor is connected to
a properly grounded electric circuit. If possible use a
ground fault circuit interrupter to protect the operator
from possible electric shock.
Figure 11. Extension Cord Connection
Summary of Contents for MP115E
Page 13: ...MP1 SERIES MASONRY SAW OPERATION AND PARTS MANUAL REV 2 10 12 17 PAGE 13 NOTES ...
Page 40: ...PAGE 40 MP1 SERIES MASONRY SAW OPERATION AND PARTS MANUAL REV 2 10 12 17 TRAY ASSY ...
Page 42: ...PAGE 42 MP1 SERIES MASONRY SAW OPERATION AND PARTS MANUAL REV 2 10 12 17 CART ASSY ...
Page 89: ...MP1 SERIES MASONRY SAW OPERATION AND PARTS MANUAL REV 2 10 12 17 PAGE 89 NOTES ...
