USER’S MANUAL
S E M S
- 27 -
-
The selection of ranges (antennas) to be measured (1, 2, 3, 4): it represents
the number of antennas systems available to the user during the
measurements. When you perform the measurements at all the points
specified previously, the system will switch range, asking you to replace the
antennas and redo the auto zero procedure.
3.3.1. Measurement using wizard
After the selection of the chamber, spots and ranges the instrument will start the
procedure to perform the auto zero required by the first set of antennas to be used.
The procedure to follow for this purpose is exactly the same of the auto zero
calibration as described in chapter 3.2.1. of this manual.
Selecting “Scan” we can choose to zeroing the system using the default mode
(L_Lo - L_Hi - BIC) or to use the span programmable by the “SEMS PC_Utility”
software mode (User).
Select the number
of ranges (antennas)
to be measured
1
2
4
8
ll
ll
ll
ll
Choose the range
for Antenna 1
(Zero)
Scan
List
ll
ll
ll
Ll