USER’S MANUAL
S E M S
- 30 -
The
Next
button must be pressed to get to the next spot. If all the required spot
have been measured, the procedure automatically switches to the next pair of
antennas and shows again the auto zeroing screenshot. If you used all the antennas
systems that you selected , the procedure is over and it will return to the main
screenshot with a success message about the data storing.
The
Redo
button repeats the measurement for the selected spot shown in the
screen, as soon as this operation is completed the display shows the same
screenshot with the updated value of the maximum attenuation.
The
End
button stops the measurements with the current set of antennas. By
pressing it the instrument will ask us to change the antennas and to start the auto
zero procedure, if the antennas systems have all been selected the procedure will
end with a message of success about the storing of the data and you will go back to
the main screenshot.
WARNING
: Pressing the “End” button in the first antennas system will reduce the
spots for all the other systems. (e.g. if I select 8 spots and I measure just 3, pressing
end will reduce to 3 the maximum number of spot per system. But if we perform a
measurement on all of the 8 spots, then we will change antennas, and then again
we will press the end button after just 3 spots measured and all the 5 spots will be
kept.