Moyer Diebel 601HTG, Manual

Page: 50 / 114

40
Installation - Model 601LTG
Pump Priming - Detergent, Rinse-aid and Sanitizer Dispensing Pumps
1. Make sure the chemical containers are full and the correct pick-up tubes are in their
containers.
2. Turn the dishwasher power switch ON. The switch will illuminate and the dishwasher
will fill with water.
3. Refer to the illustration below and note the two momentary push buttons provided to
prime the detergent, sanitizer and rinse aid pumps.
4. Open the dishwasher door and observe the inlet chute on the rear right-hand side of
the wash tank.
5. Push and hold the prime push button UP to the DETERGENT position until detergent is
observed entering the wash tank compartment. Release the push button.
6. Push and hold the same push button DOWN until sanitizer is observed entering the
wash tank compartment. Release the push button.
7. Push and hold the other push button UP to the RINSE AID position until rinse-aid
is observed entering the wash tank compartment. Release the push button.
8. Priming is complete.
PRIME
RINSE AID DETERGENT
SANITIZER
! VERY IMPORTANT !
The chemical dispensing pumps must be primed before operating the dishwasher and
whenever the chemical container is changed.
START
HEAVY DUTY
DELIME
OFF
DRAIN
ON
POWER PRIME
RINSE AID DETERGENT
SANITIZER
160
140
120
100
80
60
20
170
180
190
200
210
220
70
80
95
90
100
105
C
F
60
50
40
20
0
NSF
TE
M
P
ER
A
TU
RE
Prime
Push buttons