Moyer Diebel 601HTG, Manual

Page: 45 / 114

35
Water Connection -
601LTG
1. All models have a 6 ft. flexible hot water fill hose with a 3/4" female garden hose
connector.
2. A 1/2" or larger main incoming supply line should be installed to the dishwasher.
3. We recommend that a 1/2" or larger shut-off valve be installed in the main water supply,
as close to the dishwasher as possible for servicing.
4. The UL130 has a built-in flow control which requires that the incoming hot water supply
pressure must be between 25-95 psi.
5. The hot water supply must provide a minimum of 120°F/49°C, measured at the
dishwasher; however, 140°F/60°C is recommended.
6. A water hardness of 3 grains/gal (US) [51.3 mg/L] or less is recommended. Hard
water can adversely affect wash results.
1. All models have a 6 ft.. 5/8" I.D. drain hose. The maximum drain height connection
must not exceed 3 ft.[0.9 m].
2. A 3/4" hose barb fitting is strapped to the drain hose to connect the drain hose to a
wye drain fitting. The service part number for the hose barb is P/N 0512321.
3. The maximum drain flow is 15 US gpm/12.4 imp gpm/60 lpm.
Model 601LTG - Installation
Drain Connection - 601LTG
3/4" DRAIN HOSE BARB FITTING
STRAPPED TO DRAIN HOSE
! VERY IMPORTANT !
Make sure that the flexible water supply and drain hoses are not kinked.
Plumbing connections must allow the machine to be pulled out for service and cleaning.
Plumbing connections must comply with national, provincial local plumbing and sanitary codes. Only
qualified service personnel familiar with food service equipment should install
the machine.
The installing plumber must thoroughly flush the water supply line to remove all debris
BEFORE connecting the water supply line to the machine.
DO NOT REMOVE HOSE
CLAMPS
NOR STRETCH HOSE