Moyer Diebel 601HTG, Manual

Page: 29 / 114

19
Detergent and Rinse-aid Dispensing Pumps - Pump and Fill Adjustments
601HTG
Refer to the photo below:
1. The chemical dispensing pump run and the tank fill adjustment screws are located on the
end of the chemical circuit board swing-out bracket.
2. It is not necessary to swing the bracket out to make adjustments, but if desired, remove
the mounting nut (A) and swing the bracket (B) out and to the right.
3. Refer to the next page for adjustment instructions.
A
B
B
Installation - Model 601HTG
! VERY IMPORTANT !
Contact a chemical supplier for detergent and rinse-aid chemicals. The
chemical supplier must adjust the chemical dispensing pumps for water
hardness and food soil types.
! ATTENTION !
The amount of dispensed chemical is determined by the run time of the dispensing pump.
! VERY IMPORTANT !
INSPECT & REPLACE THE CHEMICAL DISPENSING PUMP SQUEEZE TUBES EVERY SIX MONTHS.