NPort 9000 Series CLI
Commands
2-73
2.3.3.15 udp
To configure the parameters of UDP mode for specified serial port.
Commands
udp [dest-ip1-begin
ip-address
] [ dest-ip1-end
ip-address
] [dest-port1
port
]
udp [dest-ip2-begin
ip-address
] [ dest-ip2-end
ip-address
] [dest-port2
port
]
udp [dest-ip3-begin
ip-address
] [ dest-ip3-end
ip-address
] [dest-port3
port
]
udp [dest-ip4-begin
ip-address
] [ dest-ip4-end
ip-address
] [dest-port4
port
]
udp local-port
udp-port
no udp dest-ip1-begin
no udp dest-ip1-end
no udp dest-ip2-begin
no udp dest-ip2-end
no udp dest-ip3-begin
no udp dest-ip3-end
no udp dest-ip4-begin
no udp dest-ip4-end
Syntax
Description
udp
To configure the parameters of dnp3 mode.
dest-ip1-begin
1st start ranges of IP addresses for the serial port to connect to.
dest-ip1-end
1st end ranges of IP addresses for the serial port to connect to.
dest-ip2-begin
2nd start ranges of IP addresses for the serial port to connect to.
dest-ip2-end
2nd end ranges of IP addresses for the serial port to connect to.
dest-ip3-begin
3rd start ranges of IP addresses for the serial port to connect to.
dest-ip3-end
3rd end ranges of IP addresses for the serial port to connect to.
dest-ip4-begin
4th start ranges of IP addresses for the serial port to connect to.
dest-ip4-end
4th end ranges of IP addresses for the serial port to connect to.
dest-port1
1st destination port specifies the UDP port number allows the device
server to connect actively to the remote host
dest-port2
2nd destination port specifies the UDP port number allows the device
server to connect actively to the remote host
dest-port3
3rd destination port specifies the UDP port number allows the device
server to connect actively to the remote host
dest-port4
4th destination port specifies the UDP port number allows the device
server to connect actively to the remote host
local-port
This is the UDP port that the device server listens to and that other
devices must use to contact the device server.
no
Clear the setting to empty
Defaults
The default settings for each parameter are:
Destination IP address 1 begin: blank
Destination IP address 1 end: blank
Destination port 1: 4001
Destination IP address 2 begin: blank
Destination IP address 2 end: blank
Destination port 2: 4001
Destination IP address 3 begin: blank
Destination IP address 3 end: blank
Destination port 3: 4001
Destination IP address 4 begin: blank
Destination IP address 4 end: blank
Destination port 4: 4001
Local listen port: 4001
Permission
Admin group
