AirWorks AWK-3131A
Web Console Configuration
3-14
The AeroMag function is inactive by default. The AWK-1137C supports
Client
and
Client-Router
mode
AeroMag functionality. To activate AeroMag, set the
AeroMag operation mode
to
Client
or
Client-Router
.
NOTE
You can also activate AeroMag through MXconfig, SNMP, or by using the Reset button.
Press the Reset button on the AWK-1137C
five times
to activate AeroMag client.
Press the Reset button
three times
to deactivate AeroMag (each consecutive press should be affected within
2 seconds.)
You can activate either the AP first or the Client first as the sequence of activation does not affect the behavior
of the AeroMag tool.
You can configure the following setting when AeroMag is active:
Setting
Description
Factory Default
Apply AeroMag
configuration
•
Use the current configuration:
Use the current configuration
generated by AeroMag. This option is only available if
AeroMag was already active at least once before the current
configuration change.
If you are activating AeroMag for the first time, this option
will not be available.
•
Generate a new configuration:
Discard current
configuration settings and search for an AeroMag AP to get
a new set of configuration settings.
Generate a new
configuration
You can also view the
AeroMag Client/Client-Router Operating Status
listed below:
NOTE
Select the
Auto Update
option for AeroMag to refresh the client operating status every 30 seconds. When the
AeroMag Client receives information on a change in the configuration, the
Auto Update
function refreshes the
Client’s operating status every 5 seconds.
Parameter
Description
Find AeroMag AP
AeroMag Client searches for an AeroMag AP
Identity Verification
AeroMag Client sends a connection authentication request to the AeroMag AP for the
AP to verify if the client is a Moxa device.
Apply Configuration
AeroMag AP sends a configuration that is generated for the client after the
authentication is successful. The AeroMag Client applies the assigned configuration.
AP Settings
Shows the AeroMag AP that this client is connected to and the assigned configuration
