40
English
PROG
RAMM
ING
FEATURES
English
Example of Programming Auto Scan
Auto-Scan is the last Programming Mode and
can be set to "ON" or "OFF" on a particular
channel. To set Auto Scan to “ON”:
1. Enter Programming Mode and select the
desired channel (see "Entering Programming
Mode" picture in page 38).
2. Short press the PTT button six times to enter
Auto Scan Programming Selection Mode. The
radio will signal beeps and will show the
current
Auto Scan setting (please refer to "Reading
Auto-scan Settings" in page 41).
3. Short press the SB1 button to toggle ON/
OFF the auto-scan feature in the channel.
When ON radio LED will blink RED once.
When OFF radio LED will blink ORANGE
once.
OTHER PROGRAMMING FEATURES
SCAN
Scan allows you to monitor other channels in
order to detect conversations.
When the radio detects a transmission, it will
stop scanning and will stay on the active
channel. This will allow you to listen and talk to
the people on that stopped channel without
having to change the channel knob. If there
is talking going on channel 2 during this time,
the radio will stay on channel 1 and you will not
hear channel 2. After talking has stopped in
channel 1, the radio will wait 5 seconds before
resuming scan again.
• To start scanning, press the SB2 button (*).
When the radio detects channel activity, it will
stops on that channel until the activity ends.
You can talk to the person(s) transmitting
without having to switch channels by pressing
PTT.
• To stop scanning, short press the SB2 button
again.
• By pressing the PTT button while the radio is
