34
English
PROG
RAMM
ING
FEATURES
English
Entering Programming Mode
Note:
Before programming the features, make
sure your radio is set to the channel you
wish to program. You can do so before
entering Programming Mode or at any time
during the Programming Mode by turning the
Channel Selector Knob to the desired
channel.
To read or modify frequencies, codes and
auto-scan, set the radio to 'Programming
Mode' by long pressing both the PTT and the
SB1 button simultaneously while turning ON
the radio for 3 to 5 seconds until a ‘chirp’
sounds to indicate that you have entered 'Idle'
Programming Mode (*).The radio LED will start
blinking a green heartbeat.
Note:
(*)'Idle' Programming Mode is the stage of
the Programming Mode in which the radio is
waiting for the user to start the radio
programming cycle (refer to the
Programming Mode picture above).
Once you are in the 'Idle' Programming Mode,
you will be able to read the radio frequencies,
codes and auto-scan setting by short pressing
the PTT button to move along the different
programmable features.
Reading Frequencies Values
When reading frequencies values you need to
read two digits as XTNi™ series radios have
16(*) frequencies for UHF (refer to UHF
Frequencies tables).
Once in ‘Idle’ Programming Mode, the radio
will signal the first value it was programmed
when you short press the PTT button (see
picture below). This value corresponds to the
frequency's first digit value. If you short press
the PTT button again, the radio will signal you
the second digit value.
