46
English
PROG
RAMM
ING
FEATURES
English
Operating Instructions
1. Before beginning the cloning process,
make sure you have:
• A fully charged battery on each one of the
radios.
• Two Single Unit Chargers (SUC).
• Turned OFF the radios and,
• Both radios are of the same radio model.
2. Unplug any cables (power supply or USB
cables) from the SUCs.
3. Plug one side of the cloning cable mini
connector to one SUC. Plug the other end
to the second SUC.
Note:
During the cloning process no power is
being applied to the SUC. The batteries will
not be charged. A data communication is
being established between the two radios.
4. Turn ON the Target radio and place it
into one of the SUCs.
5. On the Source radio, power the radio
following the sequence below:
• Long press the PTT button and SB2
simaltaneously while turning the radio ON.
• Wait for 3 seconds before releasing the
buttons until a distinctive audible tone is heard.
6. Place the Source radio” in its SUC, press
and release SB1.
7. After cloning is completed, the Source radio
will sound either a “pass” tone (cloning was
successful) or a “fail” tone (cloning process has
failed). The ‘pass’ tone sounds like a good key
‘chirp’ whereas the ‘fail’ tone sounds similar to
a ‘bonk’ tone. If the Source radio is a display
model it will either show ‘Pass’ or ‘Fail’ on the
display (a tone will be heard in no more than 5
seconds).
8. Once you have completed the cloning
process, turn the radios OFF and ON in order
to exit ‘clone’ mode.
