47
English
PROGRAMMING
FE
ATURES
What to do if cloning fails
The radio will emit an audible ‘bonk’ indicating
that the cloning process has failed. In the event
that cloning fails, try performing each of the
following before trying to start the cloning
process again:
1. Ensure that the batteries on both radios are
fully charged.
2. Check the cloning cable connection on both
SUCs.
3. Ensure that the battery is engaged properly
on to the radio.
4. Ensure that there is no debris in the
charging tray or on the radio contacts.
5. Ensure that the Source radio is in cloning
mode.
6. Ensure that the Target radio is turned ON.
7. Ensure both radios are both from the same
type. (same frequency band, same front panel
(display/non display), same region and same
transmission power).
Attention:
This cloning cable is designed to
operate only with compatible Motorola
RLN6170 (Rapid) Single Unit Charger.
When ordering Cloning Cable please refer to
P/N RLN6303. For details about accessories
refer to Accessories section.
Cloning using the CPS (Computer
Programming Software)
When cloning using this method, you will need
to have the CPS software, a Drop-in Tray
Charger and the CPS Programming Cable.
Information on how to clone using the CPS is
available either in the CPS Help File -->
Content and Index --> Cloning Radios or in the
CPS Programming Cable Accessory Leaflet.
Note:
(*) CPS Programming Cable is an
accessory sold separately. For part number
information refer to the Accessories Section.
