Motorola QIP7200 Series, User Manual

Page: 41 / 45

8 TROUBLESHOOTING
Before calling your service provider, review this troubleshooting guide. This
information is to help you quickly solve a problem. If your problem still exists,
contact your service provider.
Problem Possible Solution
The QIP receiver will
not power on The QIP receiver may have received a software update and may not power on while
the new software is being installed. Try again in a few minutes.
•
Verify that the AC power cord is connected to the QIP receiver and an AC
outlet. Unplug the QIP receiver from the AC outlet, plug it back in, and then
press the POWER button.
•
If the QIP receiver is connected to a switched outlet on another unit, verify
that that unit is powered on. Unplug the power cord from the QIP receiver’s
AC outlet, plug it back it in, and then press the POWER button. It is
recommended to use an unswitched outlet, if possible.
•
Press the POWER button on the QIP receiver front panel instead of the
remote control. The batteries in the remote control may be depleted.
The remote control
does not work
•
Verify that the remote control is in “set-top” mode.
•
Verify that there are no obstructions between the remote control and the QIP
receiver. Aim the remote control directly at the QIP receiver front panel, not
the TV or VCR.
The angle between the remote control and the QIP receiver may be too large. Stand
in front of the QIP receiver and not too far to either side.
•
Press and release operation keys one at a time, firmly and deliberately.
•
Try changing channels using the buttons on the QIP receiver front panel.
•
Check the batteries in the remote control. Install new batteries if needed.
There is no audio when
viewing channels
•
Verify that the mute button on the QIP receiver or the remote control has not
been pressed. Press mute on the remote control to restore sound.
•
If the QIP receiver audio output is connected to the TV, verify that the mute
button on the TV has not been pressed.
•
If the QIP receiver audio output is connected to a home theater receiver,
verify that the receiver is set to the appropriate input source and the mute
button on the receiver has not been pressed.
•
Verify that you have the correct cables for the audio connections.
•
Verify that the audio cables are firmly connected between the QIP receiver
and the audio playback device (TV, receiver, DVD player, etc.).
There is no audio from
the center and/or
surround speakers of a
home theater receiver
connected to the QIP
receiver Not all Dolby Digital
®
programs feature full 5.1 surround sound. In some cases, the
programs may only contain left and right stereo audio.
•
Verify that the S/PDIF cable (coaxial or optical) is firmly connected to the QIP
receiver and the home theater receiver.
•
Verify that the home theater receiver is set to a surround sound audio mode
(Dolby Digital, Dolby Pro Logic II
®
, Dolby Pro Logic
®
).
•
Verify that the receiver is properly configured to work with all connected
speakers.
31