Motorola PM1200, Basic Service Manual

Page: 73 / 138

6880309U09-A October 26, 2007
Disassembly/Reassembly Procedures : Replacement Procedures 6-19
12. Using a CR-V PH2 torque driver, fasten the 4 binding head screws, M4x8 SUS B [1] to the
cable relief plate [2] following the sequence as shown in Figure 6-33 . (Torqued to
5.8–6.9kgf*cm/ 5–6 in. lbs).
Figure 6-33. Sequence for Installing Cable Relief Plate Screws
6.2.3.2 RF-Interface Board Kit Disassembly/Reassembly
NOTE: Bracketed numbers are identical to item numbers shown in Figure 9-2. “PM1200 Radio
Exploded View” on page 9-3 .
6.2.3.2.1 RF-Interface Board Kit Disassembly
1. Disassemble the front panel by following the steps outlined in 6.2.3.1: “Transceiver Front
Panel Disassembly/Reassembly” on page 6-14.
2. Place the rear of the front panel facing upward on a flat surface and remove the 4 taptite head
screws, M2.6x6 [8] with a CR-V PH1 screwdriver as shown in Figure 6-34 .
Figure 6-34. Installing Remote Radio Control Cable to Front Panel
3. Carefully separate the RF-Interface unit board kit [7] from the front panel [4].
1
3
2
4
1
3
2
4