Motorola PM1200, Basic Service Manual

Page: 63 / 138

6880309U09-A October 26, 2007
Disassembly/Reassembly Procedures : Replacement Procedures 6-9
3. With the aid of a pair of long nose pliers, carefully insert each speaker fittings onto the internal
speaker [20] screw boss. Next, fasten each taptite head screw M2.6x6 [17] by using a CR-V
PH1 torque driver as shown in
Figure 6-13 . (Torqued to 3.5–4.6 kgf*cm/ 3–4 in.lbs).
Figure 6-13. Installing Speaker Fittings and Screws to Internal Speaker Bosses
NOTE: Fasten the taptite head screws by following the sequence as shown in Figure 6-14 .
Figure 6-14. Installing the Internal Speaker Screws
6.2.2.2.4 PM1200 Control Head Display Unit Board Kit Reassembly
1. Lay the rear side of the front housing assembly [10] facing upward.
2. Insert the channel group knob [4] and power knob [13] to the front housing assembly [10].
Ensure the knobs are seated properly follow the key feature as shown in Figure 6-15 .
Figure 6-15. Insert Channel Group Knob and Power Knob to Front Housing.
1
2
3
4