Motorola PM1200, Basic Service Manual

Page: 64 / 138

October 26, 2007 6880309U09-A
6-10 Disassembly/Reassembly Procedures : Replacement Procedures
3. Carefully align and insert the display unit board kit [22] to the key unit board kit [16].
NOTE: The male connector pin at the display unit board kit [22] might break if improperly assemble.
4. Carefully place the display unit board kit [22] to ensure the male connector pins are fully
engaged to the female connector.
5. Using a CR-V PH1 torque driver, fasten the 6 taptite head screws M2.6x6 [17] following the
sequence shown in Figure 6-16 (torqued to 3.5–4.6 kgf*cm/ 3–4 in. Ibs).
Figure 6-16. Display Unit Board Screw Sequence.
6. Carefully connect the speaker wire to the mating connector as shown in Figure 6-5 .
Figure 6-17. Connecting Speaker Mating Connector.
7. Carefully seal the front housing assembly [10] with the rubber packing [11].
6.2.2.2.5 PM1200 Control Head Panel-Interface Unit Board Kit Reassembly
1. Carefully connect the connection cable to the mating connector on the rear of display unit
board kit [22] as shown in Figure 6-18 .
1
2
3
4
5
6
Speaker Mating Connection