Hardware Installation
http://www.motorola.com/computer/literature
1-45
1
!
Warning
Dangerous voltages, capable of causing death, are present in this
equipment. Use extreme caution when handling, testing, and adjusting.
3. Remove the filler panel(s) from the appropriate card slot(s) at the
front or rear of the chassis. (You may need to shift other modules in
the chassis to allow space for the MVME712M, which has a double-
wide front panel.)
4. Attach the P2 adapter board to the P2 backplane connector at the slot
occupied by the MVME2603/2604 VME module.
5. Route the 64-conductor cable furnished with the MVME712M from
J2 on the P2 adapter board to J2 on the transition module. Be sure to
orient cable pin 1 with connector pin 1.
!
Caution
Avoid touching areas of integrated circuitry; static discharge can damage
these circuits
6. Secure the MVME712M in the chassis with the screws provided,
making good contact with the transverse mounting rails to minimize
RF emissions.
7. Referring to the user’s manual for the MVME712M (listed in
Appendix D, Related Documentation
), route the 50-conductor cable
to the internal or external SCSI devices as appropriate to your
system configuration. Be sure to orient cable pin 1 with connector
pin 1.
Note
The SCSI cabling can be configured in a number of ways to
accommodate various device and system configurations.
Figure
1-21
shows a possible configuration for use with internal SCSI
devices. For more detailed information on installing the P2
adapter board and the MVME712M transition module, refer to
the user’s manual (listed in
Appendix D, Related
Documentation
).
