1-44
Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
7. If necessary, install an MVME712M or MVME761 transition
module and cable it to the MVME2603/2604 as described in the
following sections of this document.
8. Replace the chassis or system cover(s), cable peripherals to the
panel connectors as appropriate, reconnect the system to the AC or
DC power source, and turn the equipment power on.
MVME712M Transition Module Installation
This section applies to MVME712M-compatible models of the
MVME2603/2604 VME module. With the MVME2603/2604 installed,
refer to
Figure 1-21
and proceed as follows to install an MVME712M
transition module:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VME modules.
!
Caution
The MVME2600, MVME712-compatible models will be damaged if
mistakenly connected to the MVME761 transition modules instead of the
correct MVME712 family of boards.
Note
In models of the MVME2603/2604 that are configured for
MVME712M I/O mode, the pin assignments of VMEbus
connector P2 are fully compatible with other transition modules
of the MVME712 series.
!
Caution
Inserting or removing modules with power applied may result in damage
to module components.
