73
Appendix
Configuring Port and Dial Settings
If you are installing data modem on a computer or hand-held device that
does not use Windows 95, Windows 98, or Windows NT, configure your
port and dial settings, as follows:
Baud rate=19200
Data bits=8
Stop bits=1
Parity=None
Duplex=Full
Dial Method=Tone
Flow Control=Hardware
Data Initialization String=AT&K3
If the hardware flow control is not supported, set the Data Initialization
String to AT&K4.
Configuring the Modem with AT Commands
If you are not using the Installation disk, configure your
AT command set using the following guidelines.
Enter the command indicated next to Command Syntax.
Restore Factory Defaults
First, restore the current values to their factory default values. This will
ensure a clean start for the rest of the configuration.
N O T E
DCE refers to the modem on your iDEN modem.
DTE refers to your computer or hand-held computing
device.
AT Command
Restore Factory-Default Configuration
Command Syntax
AT&F
Expected Return Code(s)
OK
