Issues and Solutions
Home Monitoring & Control System
53
MHM
User
Guide
Control Panel Issues and Solutions
Sensor status is displayed as
no data available yet
after the MHM program is
restarted.
After the MHM program has been restarted, sensor status may be displayed with a status of
no data available yet
for up to 20 minutes while the system re-establishes communications
with the sensors.
Wired camera is displayed on the device list with a RED icon with a status of
not connected.
The wired camera was discovered and functioned properly, but is reporting a status of not
connected. Take the following steps to correct this condition:
1
Disarm the MHM system.
2
Select the wired camera from the drop down menu.
3
Verify that the there is no image present from the camera. If you see an image from the
camera, try closing and then restarting the MHM program.
4
Check the connection to the camera on the rear of the USB Gateway.
5
If the 60-foot extension cable is used, remove it to eliminate it as a source of the
problem.
6
Go to Discovery, delete the camera, and re-discover it.
Summary of Contents for EASY START KIT HMEZ1000 - CELL PHONE SET UP
Page 1: ......
Page 9: ......
Page 84: ...Visit our website at www motorola com homemonitoring 506229 001 08 04 MGBI ...
