Motorola EASY START KIT HMEZ1000 - CELL PHONE SET UP, User Manual

Page: 11 / 84

Home Monitoring & Control System Installation
2 MHM User Guide
Installation
IMPORTANT: Do not connect your USB Gateway to your computer until the installation
wizard prompts you.
Install your system with these simple steps:
1 Insert the installation CD to guide you through installing your Motorola Home Monitor
(MHM) program on your computer and activating your hardware.
2 The set up wizard helps you configure the software on your computer and indicates
when you should physically attach the USB Gateway.
3 If necessary, install additional hardware.
If you purchased additional devices after this set up routine, they can be installed using the MHM program at a
later date. See
Discover New Devices for further details.
Installing Software and Hardware
If you are installing the software on a Windows Me computer, you must disable the Hibernation (power save)
mode after you complete the installation. If not, when the computer enters Hibernation mode, the program will
exit when the user wakes up the system. Please refer to
Disabling Hibernation Mode on Windows Me for further
instructions. This is not the same as the screensaver. The screensaver will not interfere with the operation of
the MHM program.
1 Before connecting the hardware, place the Software CD in your computer’s CD-ROM
drive. The set up wizard starts automatically.
1
Accept the License Agreement.
2 Select Install Required Software .
3 When the introductory Installation window is displayed, click Next .
4 From the Choose Destination Location window, either accept the default destination or
select a new one by clicking
Browse . Once satisfied with the destination, click Next .
1
Note: If the Windows set up wizard does not start automatically, do the following: Click Start , then
Run . On the next screen, click Browse and locate your CD-ROM drive. Locate Launch.exe and
highlight it. Click Open , then OK . The set up wizard starts.