Accessories
A - 5
Wall Mount Setup
A Cradle Base is available for mounting a CA10 cradle on a wall.
Wall mounting requires hanging the cradle along its width (or length) using the four slots on the bottom side of the
cradle base and using the bracket itself as a mounting template for the screws.
The cradle can be mounted onto any plaster, concrete or wood wall surface provided the appropriate hardware is
used.
The mounting hardware and tools (customer-provided) required to install the cradle on a wall are:
•
Four Phillips pan head self-tapping screws #6-18 X 0.875in (see
Figure A-7
). Type A or AB self-tapping
screws, or (ANSI Standard Metric) M3.5 X 0.6 X 20mm Type D self-tapping screws
•
Four wall anchors
To mount the cradle to a wall:
1.
Orient the Cradle Base on the wall by its width or length.
2.
Using the cradle base as a template, mark points on the midline of the slots for the screws and remove the
cradle base.
3.
At each point, drill a hole in the wall, insert an anchor, screw the wall mounting screw into the anchor and stop
when there is 3.2mm (0.125 in.) between the screw head and the wall.
If pre-drilling a hole, the recommended hole size is 2.8mm (0.11in.) if the screws are going directly into the wall
and 6 mm (0.23 in.) if wall anchors are being used.
4.
Align the four slots on the cradle base with the screws on the wall. Attache cradle base to the wall and press
downwards to lock the cradle base into place (see
Figure A-7
).
Figure A-7
Wall Installation of Cradle Base
NOTE
For safe mounting, it is essential to use wall anchors appropriate to the wall type (i.e. plaster, wood,
concrete, etc.). Mount to wood studs whenever possible.
Summary of Contents for CA10
Page 1: ...CA10 User Guide ...
Page 2: ...CA10 User Guide 72E 124942 01 Revision A August 2009 ...
Page 5: ...iv CA10 User Guide ...
Page 11: ...x CA10 User Guide ...
