Accessories
A - 3
To set the cradle on a desktop using a
Cradle Base
:
1.
Position the Power Supply Unit inside the Cradle Base and connect the AC Line Cord to the Power Supply Unit
(see
Figure A-2
). Do not plug the AC Line Cord into an AC power outlet.
Figure A-2
Desktop Base
2.
Wrap the spare length of the DC Cable around the Cable Guides (see
Figure A-3
).
Figure A-3
Cable Guides
3.
Route the DC Cable out of the cradle through the Cable Holders (see
Figure A-4
). Use the Cable Notch as an
end point guide to measure the length of cable required for reaching the DC power connector.
Figure A-4
DC Cable Route
Cradle Base
Power Supply Unit
AC Line Cord
Cable Guides
Cable Holders
Cable Notch
DC Cable
See cable notch mark
on the cradle base wall
Summary of Contents for CA10
Page 1: ...CA10 User Guide ...
Page 2: ...CA10 User Guide 72E 124942 01 Revision A August 2009 ...
Page 5: ...iv CA10 User Guide ...
Page 11: ...x CA10 User Guide ...
