Getting Started
1 - 7
Charging
This section describes how to use the 10-Slot CA10 Charge Cradle with the CA10 units.
The cradle supports simultaneous charging of up to ten CA10 units. Charging status is indicated via the Status LED
on the CA10.
The CA10 has an internal, non-replaceable battery. Before using the CA10 for the first time, fully charge the battery
until the Status LED shows steady green (see
Table 1-2
for charge status indications). The CA10 fully charges in
less than 3 hours and provides up to 10 hours of typical functionality.
To charge the CA10 using the 10-Slot CA10 Charge Cradle (see
Figure 1-5
):
1.
Install the cradle. Proper connection of AC line power to the cradle is indicated via the green Power LED on the
cradle (see
Cradle Installation Options on page A-2
).
2.
Disconnect the Lanyard Clasp of the Lanyard Extension (see
Figure 1-1
).
3.
Place the CA10 onto a Magnetic Charging Base on the cradle (see
Figure 1-5
).
4.
The CA10 starts to charge automatically. The Status LED on the CA10 indicates the charge status. See
Table
1-2
for charging indications.
Figure 1-5
Using the 10-Slot CA10 Charge Cradle for Charging the CA10
CAUTION
Note that the charging temperature is monitored and controlled by the CA10 and the cradle.
Charging is halted at temperatures above 40°C (104° F).
NOTE
When charging, the CA10 cannot be used for communication although the wireless connection
to the network remains active.
A
A
Status LED
Power LED
Magnetic
Charging
Base
Summary of Contents for CA10
Page 1: ...CA10 User Guide ...
Page 2: ...CA10 User Guide 72E 124942 01 Revision A August 2009 ...
Page 5: ...iv CA10 User Guide ...
Page 11: ...x CA10 User Guide ...
