Motorola AP 6522M, Installation Manual

Page: 5 / 48

Installation Guide 5
1 Introduction
The AP 6522M Access Point, a component of the wireless controller system, links wireless 802.11abgn devices to
the controller, enabling the growth of your wireless network with a cost effective alternative to standard Access
Points. The AP 6522M Access Point provides multiple deployment options.
The AP 6522M Access Point receives all power and transfers data through the same CAT-5 or better Ethernet
cable. An 802.3af Ethernet switch or power supply (specifically rated for the AP 6522M) is required (Part No.
PWRS-14000-148R).
An AP 6522M model Access Point uses WiNG software as its onboard operating system. The Access Point’s
unique WiNG 5 software enables the Access Point to function as either a Virtual Controller AP capable of
adopting and managing up to 24 additional AP 6522M Access Points, a Standalone Access Point, or a Dependent
mode Access Point managed by its connected controller.
The AP 6522M Access Point is approved under MODEL: AP-0622.
This document is written for the qualified network device installer.
1.1 Document Conventions
The following graphical alerts are used in this document to indicate notable situations:
NOTE
Tips, hints, or special requirements that you should take note of.
CAUTION
Care is required. Disregarding a caution can result in data loss or
equipment malfunction.
WARNING!
Indicates a condition or procedure that could result in personal injury or
equipment damage.
!