C-2
Front and Back Panels
LEDs
LEDs
Introduction
The AL 200 front-panel LEDs offer diagnostic and connectivity status information.
This section lists the LED states.
LEDs
This table describes the AL 200’s front-panel LEDs. For information on LED status
during modem states of operation, refer to the Diagnostics section in the Motorola io
cable modem DM 100 Installation Manual.
-->>>**this statemnt comes from the older PL 100 manual. COnfirm with Peg
Burbank or remove. Same for the same statement, next page.
Cable Modem LEDs
LED
Name
Indicates
Power
Power
Whether electrical power is applied to the
modem
S1
Status 1
The modem state (refer to the “S1, S2, and S3
LEDs” section on page C-3)
S2
Status 2
S3
Status 3
PC
Personal
Computer
Whether the cable modem is connected to
customer premise equipment (CPE)
TRANSMIT
Transmit Data
That the multi-user modem is transmitting data
(on the HPNA port, Ethernet port, or both) to a
computer or CPE on the home network
RECEIVE
Receive Data
That the multi-user modem is receiving data
(on the HPNA port, Ethernet port, or both) from
a computer or CPE on the home network
MESSAGE
Message
The function of this LED is defined by the cable
system operator
Summary of Contents for AL 200
