1-8
The Motorola AL 200 Multi-User Modem
Installing the AL 200
AL 200 Cable
Connections
Folow these steps.
Wireless Computer
Connections
Follow these steps for each computer:
Steps to Connect Home RF on AL 200
Step
Action
1
Connect a coaxial cable to the CABLE connector on the back of the AL 200
and to the cable termination point.
2
Connect the power cable to the POWER connector on the back of the AL
200.
3
Plug the wall-mount power supply into a standard electrical outlet.
The LEDs blink in the power-up sequence, then the POWER, S1, S2, and
S3 LEDs remain on. The PC LED goes on, or flickers rapidly, when a
computer is detected on the line.
**/Open Issue/from Mike McGovern/ AL 200 must be registerd before PC
can receive IP address/ resolve w/ Mike
Steps to Connect Home RF/USB or RF/PCMCIA Clients
Step
Action
1
Connect an RF antenna/adapter to the computer’s USB or PCMCIA port.
Refer to Figure 1-2.
The New Hardware Found dialog box appears; then the Add New Hardware
Wizard window.
2
Click Next. Follow the on-screen instructions. Windows installs the
network adapter driver and the required Windows files.
Note
This step requires the Windows disk. After loading files from the Windows
disk, remove the disk (before restarting the computer).
3
**Set the security ID ?/Mike/Tom
**Tell user not to follow Windws instructions--follow Symph instructions-
-for driver install??
Summary of Contents for AL 200
