Encore Networks EN-4000, Reference Manual

Page: 1 / 6

For information on trademarks, safety, limitations
of liability, and similar topics, see
http://www.encorenetworks.com/disclaimer.htm .
Go to Table
of Contents
Setting the EN-4000’s Modem
to Use AT Commands
his document describes how to set the EN-4000’s modem for use of Hayes
Attention (AT) commands.
D.1 Opening a Modem Port
1
Download putty.exe (Putty shareware) from the Internet and install it on a laptop.
2
Connect the laptop’s Ethernet port to a LAN port on the EN-4000 router.
3
Enable DHCP client mode on the laptop.
❖
This laptop will request its IP address from the EN-4000.
4
Connect power to the EN-4000 router. Wait for a minute.
❖
This EN-4000 assigns an IP address to the laptop.
5
Open an Internet browser, and type the EN-4000’s LAN IP address
( 192.168.10.1 ) in the browser's address bar.
❖ If the connection is good, you will see Encore Networks' logo and the login
prompt.
6
Use the credentials to log into the EN-4000 from the browser.
Note: For EN-4000™ routers, the default login name (or user name) is root .
(For all other EN™ routers, the default user name is admin .) In addition:
• Devices shipped before July 09, 2018, use the default password encore!1 .
• Devices shipped from the factory on or after July 09, 2018, use a randomly
generated default password. That password is contained in information on a
sticker on the bottom of the router's chassis. Retain that sticker; you will need
that default password if the router must be reset. (For details, see the
document Password Policy for EN™ Routers .)
T
EN-4000™ Reference Manual
Document D
Version A.2, September 2019
© 2019 Encore Networks, Inc.
All rights reserved.