A p p l i c a t i o n V i e w s
S u p p o r t e d A p p l i c a t i o n s
D e v i c e M a n a g e m e n t
Page 60
M o t o r o l a V a n g u a r d
to acknowledgment time-out, before the logical
link will be declared down (inoperative).
Receive Ack Count
The number of frames the link station will receive
from the remote station before acknowledging
receipt.
Tx Window Size
The maximum number of I frames a station may
transmit without acknowledgment.
Tx Data Priority
The transmission priority of the LLC LT data over
WAN.
The bottom portion of the WAN Bridge Link Info
view is the 802.1d Base Link Group table, which
lists settings for individual bridge links. Column
headings are as follows:
LnkIndex
Number (5-36) identifying a particular WAN
bridge link.
LnkType
Identifies the type of bridging employed on this
link.
AddrFiltAction
Determines whether the link will
pass
or
block
frames with a MAC address that are not listed in
the MAC Address Filter Table. A setting of “none”
indicates no MAC address filtering will be
performed for this link.
ProtFiltAction
Determines whether the link will
pass
or
block
frames with a Protocol value that are not listed in
the Protocol Filter Table. A setting of
none
indicates no MAC address filtering will be
performed for this link.
LnkManState
Determines whether to
forward
or
block
an STE
(or Single Route Broadcast ) frame when the Stp
Control parameter is set to
Man
.
Address Table Parameters View
Access:
In the Bridge Configuration Information view, click
the Permanent Address Table button.
This view contains a table with entries for up to
8000 permanent MAC addresses that are loaded
into the Forwarding Table after a table or node
boot. Each entry identifies the bridge link
(
LinkNum
) to which frames with the given MAC
address will be forwarded.
