8A
8B
13
12
15
14
11
14
16
15
12
13
EN
EN
Pay attention to the installation dimensions mentioned on pages 4B, 5 and 6!
01
• Fix the supports.
• The rear support must be fixed on the pillar
or wall.
• The front support must be fixed on the gate.
Respect the height and distance measures
between the front and rear supports.
It can be fixed by using screws with
mechanical bushing or chemical welding
process, because both provide an appropriate
support.
04. INSTALLATION
INSTALLATION STEPS
INSTALLATION STEPS
03
• Test the movement.
02
• Install the motor on the supports
• The motor must be placed on both supports
the same time to avoid leaving the motor sus-
pended by only one of the supports.
To make the task easier, you should unlock the
motor in order to be able to stretch/retract
arm easily (see page 4A),to get the correct po-
sition for supports.
• Install the pins removed earlier on each side with a small amount of lubricant for less
friction.
• Unlock the motor and move the door manually to see if the door opens and closes uniformly
and correctly, without any irregular friction during its entire movement.
This will ensure that the motor is not subjected to problems during operation.
04. INSTALLATION
04
• Connecting the motor to control board and con-
figuring control devices.
• With the motor installed, connect it to control board
for system configuration (see control board user
manual).
It is important to configure the desired control
devices (remote controls, wall switch, etc.) and other
additional components such as antenna, flashing light,
key selector, among others.
It is important to respect this installation order!
Otherwise, it is not possible to ensure correct installation and the motors may not work
properly!
