19
JUMP-ST
AR
TING
Y
OUR
VEHICLE
Positive Grounded Battery
+
+
–
+
+
–
MD
®
JUMPER / DÉMARREUR
ON
MARCHE
OFF
ARRÊT
3.1A USB
AIR
3
4
18
JUMP-ST
AR
TING
Y
OUR
VEHICLE
W A R N I N G
A SPARK NEAR A BATTERY MAY CAUSE A BATTERY EXPLOSION.
Important
Make sure the Compressor Power Button has been turned OFF before
attempting to use the unit as a Jump-Starter.
JUMP-STARTING YOUR VEHICLE
(cont’d)
JUMP-STARTING YOUR VEHICLE
(cont’d)
Turn off vehicle ignition and all
accessories (radio, A/C, lights,
connected cell phone chargers,
etc.), put vehicle in “park” and
set emergency brake.
Make sure the Jump-Starter
Power Switch is turned to OFF.
IMPORTANT –
To reduce the risk of
a spark near battery:
•
Stay clear of fan blades, pulleys,
and other parts that can cause
injury.
•
Check polarity of battery posts.
A positive (POS, P, +) battery post
usually has a larger diameter than
a negative (NEG, N, –) battery
post.
•
Remove jumper clamps from
clamp tabs.
NEVER
allow the DC
output clamps to touch
each other. This may
cause a spark.
Connect the negative (black)
clamp from the battery
booster to the negative (NEG,
N, -) ungrounded post of the
battery.
Connect the positive (red)
clamp from battery booster to
the vehicle chassis (must be
a heavy gauge metal part
of the frame) or engine block
away from the battery.
DO NOT
connect the clamp
to carburetor, fuel lines or
sheet metal body parts.
When the clamps are
connected properly, the backlit
LCD screen will display the
following to indicate the unit is
ready to jump-start:
The Battery Status icon, Battery
Voltage Indicator, Clamp Icons
and the “+” and”–” signs light
solid. The jump starter icon will
flash to indicate the clamps are
properly connected.
Turn the Jump-Starter Power
Switch on.
.
Turn on ignition switch and
crank the engine in 5-6 second
bursts until engine starts. The
backlit LCD screen will display
the following:
The Battery Status Icon, the
Battery Voltage Indicator, Jump
Starter Icon, Clamp Icons and
the “+” and”–” signs light solid
to indicate the unit is jump-
starting.
Turn the Jump-Starter Power
Switch back to the OFF
position.
Disconnect the
negative (–) clamp first, then
disconnect the positive (+)
clamp.
Important
Always turn the unit off when
not in use. Recharge this unit
fully after each use.
J7C09ME_11-1913_EN_082418.indd 18-19
8/24/2018 11:15:45 AM
