21
W A R N I N G
To reduce the risk of injury or property damage
•
Follow all safety instructions found in the “Specific Safety Instructions
for Jump Starters” section of this instruction manual.
•
Never touch red and black clamps together. This can cause dangerous
sparks, power arcing, and/or explosion.
•
If the clamps are connected incorrectly with regard to polarity, the unit
will sound a continuous alarm until the clamps are disconnected. The
backlit LCD Screen will display the Battery Status Icon, the Battery Voltage
Indicator and the Clamp Icons. The “+” and”–” signs above the Clamp Icons,
the Arrow Icons and the Alarm Icon will flash. The backlit LCD screen will
display the following:
C A U T I O N
To reduce the risk of injury or property damage
•
The unit will suffer permanent damage if the Jump Starter Power Switch
is turned on while the clamps connected with reverse polarity. Disconnect
the clamps and reconnect to battery with correct polarity.
•
If the Jump Starter Power Switch is turned on and the unit detects that the
clamps are not connected to a battery, a two-second warning will sound
every 10 seconds. The LCD screen will display the Battery Status Icon, the
Battery Voltage Indicator, and the Clamp Icons with the “+” and”–” signs.
The Alarm Icon and the Jump Starter Icon will flash. The backlit LCD screen
will display the following :
Turn off the Jump Starter Power Switch; connect the clamps to the battery,
making sure the clamps are connected with correct polarity; then turn the
Jump Starter Power Switch back on.
•
Vehicles that have on-board computerized systems may be damaged if
vehicle battery is jump-started. Before jump-starting this type of vehicle,
read the vehicle manual to confirm that external-starting assistance is
advised.
•
Excessive engine cranking can damage the vehicle‘s starter motor. If
the engine fails to start after the recommended number of attempts,
20
W A R N I N G
A SPARK NEAR A BATTERY MAY CAUSE A BATTERY EXPLOSION.
Important
Make sure the Compressor Power Button has been turned OFF before
attempting to use the unit as a Jump-Starter.
Turn on ignition switch and
crank the engine in 5-6 second
bursts until engine starts. The
backlit LCD screen will display
the following:
The Battery Status Icon, the
Battery Voltage Indicator, Jump
Starter Icon, Clamp Icons and
the “+” and”–” signs light solid
to indicate the unit is jump-
starting.
Turn the Jump-Starter Power
Switch back to the OFF
position.
Disconnect the
positive (+) clamp first, then
disconnect the negative (–)
clamp.
Important
Always turn the unit off when
not in use. Recharge this unit
fully after each use.
JUMP-ST
AR
TING
Y
OUR
VEHICLE
JUMP-STARTING YOUR VEHICLE
(cont’d)
JUMP-ST
AR
TING
Y
OUR
VEHICLE
JUMP-STARTING YOUR VEHICLE
(cont’d)
J7C09ME_11-1913_EN_082418.indd 20-21
8/24/2018 11:15:46 AM
