27
USING
THE
C
OMPRESSOR
Inflating Tires or Products With Valve Stems
Screw the Sure Fit® nozzle onto the valve stem. Do not overtighten.
Press the Compressor Power Button. A beep will sound and the backlit
LCD screen will display the following:
The Compressor Icon will light and the digital display will alternately
show the flashing pre-set PSI value (that was last set by the compressor
pressure control buttons) and the current pressure of the item being
inflated (which will light solid).
Press the “+” and “–” Pressure Control Buttons to set the desired
pressure from a range pre-set values (between 1 and 120), which will
display on the backlit LCD screen. The unit will sound a beep with
each press of the buttons (holding the button speeds up the upward
or downward value selection). Once the desired pressure has been
entered, release the button and the flashing digital display will show
the new selected pressure, as follows:
The new selected value is now stored in the unit’s memory until it is
manually reset.
Press the Compressor Power Button once more to begin inflating.
The Compressor Icon will flash and the digital display will only show
the current pressure value (which will light solid) to indicate the
compressor is activated. Monitor the pressure on the LCD screen.
IMPORTANT NOTE:
To interrupt during inflation, press the Compressor
Power Button again.
When desired pre-set pressure is reached, the compressor will
automatically stop.
Press the Compressor Power Button again to turn off the unit.
Unscrew and remove the Sure Fit® nozzle from the valve stem.
Allow the unit to cool, then recharge before storing away.
Store the compressor hose and Sure Fit® nozzle in storage
compartment.
26
USING
THE
C
OMPRESSOR
Important
Make sure the Jump-Starter Power Switch has been turned OFF before
attempting to use the unit as a Compressor.
W A R N I N G
To reduce the risk of serious injury or property damage,
follow all safety instructions found in the “Specific Safety
Instructions for Compressors” section of this instruction manual.
C A U T I O N
To reduce the risk of injury or property damage
When the compressor is operated at a low PSI, the unit may start in low and
gradually rev up. When the compressor is operated at higher PSIs, the unit
may operate normally for several minutes, then rev down for a few minutes
before returning to normal operation.
This feature protects the unit from overheating during normal use. In any
event, do not operate compressor continuously for longer than 10 minutes,
as it may overheat. This could damage the compressor.
If the compressor must be operated for longer periods: every 10 minutes
press the Compressor Power Button to turn the compressor off, then restart
after a cooling down period of approximately 30 minutes.
USING THE COMPRESSOR
(cont’d)
USING THE COMPRESSOR
(cont’d)
J7C09ME_11-1913_EN_082418.indd 26-27
8/24/2018 11:15:47 AM
