Mortara ELI 150 Rx, User Manual

Page: 55 / 76

Configuration Page 6
The ELI 150 Rx connectivity options are RS-232 (or direct), internal or external modem, LAN, WLAN,
or GSM/GPRS mobile. Configuration parameters associated with each type of transmission media will
be presented in Configuration pages 6 and 7 only if those media are installed in the electrocardiograph.
XMT Media
Identifies the default transmission media; those connectivity options which have been optionally purchased
and installed will be available for default selection.
DHCP
Defines whether the Dynamic Host Communication Protocol (DHCP) will be used to obtain an IP address. If
DHCP is Yes, the network will automatically and dynamically assign an IP address. If DHCP is No, you must
enter the IP address, def gateway, and sub net mask.
NOTE: All parameters related to network connection must be entered under the direction of
the IT Manager of the facility where the device is installed.
IP Address
Enter the fixed IP address for network transmissions (if DHCP is not selected).
Def Gateway
Enter the address of the default gateway (if DHCP is not selected).
Sub Net Mask
Enter the sub net address (if DHCP is not selected).
Host IP
Enter the IP address of the host server.
NOTE: Addresses are always entered as 4 sets of 3 digits; therefore, an address of 192.168.0.7
must be entered as 192.168.000.007.
Port Number
Enter the port number used by the host server.
SSID
Service Set Identifier (SSID) is the name of the wireless network. All ELI 150 Rx electrocardiographs that
will transmit to the same network must have the same SSID name. This field is case sensitive.
SECTION 4
33