Table X-3 Guidance and Manufacturer’s Declaration: Electromagnetic Immunity
The equipment is intended for use in the electromagnetic environment specified in the table below. The
customer or the user of the equipment should ensure that it is used in such an environment.
a. Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios,
amateur radios, AM and FM radio broadcast, and TV broadcast cannot be predicted theoretically with accuracy. To assess the
electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be considered. If the measured
field strength in the location in which the equipment is used exceeds the applicable RF compliance level above, the equipment
should be observed to verify normal operation. If abnormal performance is observed, additional measures may be necessary, such
as reorienting or relocating the equipment.
b. Over the frequency range 150 kHz to 80 MHz, field strengths should be less than [3] V/m.
ELECTROMAGNETIC COMPATIBILITY (EMC)
(Continued)
xvii
Emissions Test
IEC 60601 Test Level
Compliance Level
Electromagnetic Environment: Guidance
Portable and mobile RF communications
equipment should be used no closer to any
part of the equipment, including cables, than
the recommended separation distance
calculated from the equation applicable to
the frequency of the transmitter.
Recommended separation distance
Conducted RF
3 Vrms 150 kHz
3 Vrms 150 kHz
IEC 61000-4-6
to 80 MHz
to 80 MHz
80 MHz to 800 MHz
Radiated RF
3 V/m 80 MHz
3 V/m 80 MHz
IEC 61000-4-3
to 2.5 GHz
to 2.5 GHz
800 MHz to 2.5 GHz
Where
P
is the maximum output power rating
of the transmitter in watts (W) according
to the transmitter manufacturer and
d
is
the recommended separation distance in
meters (m).
Field strengths from fixed RF transmitters,
as determined by an electromagnetic site
survey
a
, should be less than the compliance
level in each frequency range
b
.
Interference may occur in the vicinity of
equipment marked with the following symbol:
Summary of Contents for ELI 150 Rx
