ELECTROMAGNETIC COMPATIBILITY (EMC)
(Continued)
xvi
Table X-1 Guidance and Manufacturer’s Declaration: Electromagnetic Emissions
The equipment is intended for use in the electromagnetic environment specified in the table below. The
customer or the user of the equipment should ensure that it is used in such an environment.
Table X-2 Guidance and Manufacturer’s Declaration: Electromagnetic Immunity
The equipment is intended for use in the electromagnetic environment specified in the table below. The
customer or the user of the equipment should ensure that it is used in such an environment.
NOTE:
UT is the AC Mains voltage prior to application of the test level.
Emissions Test
Compliance
Compliance Level
Electromagnetic Environment: Guidance
Electrostatic
+/- 6 kV contact
+/- 6 kV contact
Floors should be wood, concrete, or ceramic tile.
discharge (ESD)
+/- 8 kV air
+/- 8 kV air
If floors are covered with synthetic material, the
IEC 61000-4-2
relative humidity should be at least 30%.
Electrical fast
+/- 2 kV for
+/- 2 kV for
Mains power quality should be that of a typical
transient/burst
power supply lines
power supply lines
commercial or hospital environment.
IEC 61000-4-4
+/- 1 kV for
+/- 1 kV for
input/output lines
input/output lines
Surge
+/- 1 kV differential
+/- 1 kV differential
Mains power quality should be that of a typical
IEC 61000-4-5
mode +/- 2 kV
mode +/- 2 kV
commercial or hospital environment.
common mode
common mode
Voltage dips, short
<5% UT
<5% UT
Mains power quality should be that of a typical
interruptions, and
(>95% dip in UT)
(>95% dip in UT)
commercial or hospital environment.
voltage variations
for 0.5 cycle
for 0.5 cycle
on power supply
40% UT
40% UT
input lines
(60% dip in UT)
(60% dip in UT)
IEC 61000-4-11
for 5 cycles
for 5 cycles
Power frequency
3 A/m
3 A/m
Power frequency magnetic fields should be at levels
(50/60 Hz)
characteristic of a typical location in a typical
magnetic field
commercial or hospital environment.
Emissions Test
Compliance
Electromagnetic Environment: Guidance
RF Emissions CISPR 11
Group 1
The equipment uses RF energy only for its internal function.
Therefore, its RF emissions are very low and not likely to
cause any interference in nearby electronic equipment.
RF Emissions CISPR 11
Class A
The equipment is suitable for use in all establishments other
than domestic and those directly connected to the public
low-voltage power supply network that supplies buildings
Harmonic Emissions
Complies
used for domestic purposes.
IEC 61000-3-2
Voltage Fluctuations/Flicker
Complies
Emissions IEC 61000-3-3
Summary of Contents for ELI 150 Rx
