Morpheus Technologies Owner’s Manual
http://www.BaseRigs.com/
Page 15 Morpheus Technologies
Figure 1
Figure 1: Follow the canopy manufacturer’s instructions for packing the canopy until it
resembles the drawing above. Fold the top flap and the yoke area under the container.
(This fold is also used at a later stage as a guide to determine where to fold the canopy.)
Tuck the bottom flap under the container, as well.
Figure 2
Figure 2: Grasp the canopy and the Tail Pocket so as not to disturb the stowed lines and
slide the cocooned canopy over and into the pack tray ensuring the risers don’t get
twisted. Lay the tail pocket and canopy flat on the bottom of the pack tray with the rear
risers toward the inside. If you have Big Grab toggles, just have them face each other in
the pack tray. Position the canopy squarely and ensure that the tail pocket fills the
bottom corners of the pack tray.
