Morita DENTA PORT ZX, Operation Instructions Manual

Page: 9 / 36

Operation 2018-03-22
Page5
3. Assembling the Unit
Placing the Batteries

Canal Measurement Module is shipped without the
batteries installed. Remove the cover and install the 3 AA
batteries.
1. Hold the cover and slide the stopper on the bottom towards
the liquid crystal display.
2. Slide the cover in the direction indicated by the arrow in the
illustration and remove it from the Canal Measurement
Module.
3. Place the 3 AA batteries included in the package as indicated
on the equipment.
(1) Insert the batteries by first pressing center of the minus
end against its spring contact and then sliding the plus end
down into place.
(2) Make sure the contacts are not bent or damaged.

Do not reverse the plus and
minus poles.

Never allow the spring contact
to push against the edge of the
battery. This could damage
the outer cover causing a short
or a leakage of battery liquid.
4. Line up the tabs on the cover with the notches on the Canal
Measurement Module and slide the cover on.
5. Slide the cover all the way down until it is securely attached.

If the catch on the bottom is not back in its original place
after attachment, push it in the direction shown by the
arrow in the illustration.

After installation, give the cover a light tug to confirm it is
securely attached
Notches Tabs
Canal Measurement
Module Cover
Cover
2
Cover
Canal Measurement
Module
4
5
Stopper
Cover
Canal Measurement Module
1
3
BAD