N U M B E R E R
PAGE 33
Section 10
MAINTENANCE
10.6 .....Numbering Head - Re-assembly
Fit the appropriate wheel and position it so that the centre shaft
can be pushed back into place using the drift. The centre shaft is
then aligned so that it’s ends are flush and the slots in the ends are
horizontal.
Tighten screw ‘C’ until it is flush with the frame. If it will not go
flush, re-align the centre shaft and try again.
Fit the action lever ,ensuring that its operating pin engages in the
hole in the actuating pawl bar. Operate the action lever up and
down to confirm correct assembly and operation. Now tighten
screw ‘A’ until it is just clear of the end of the action lever spindle.
Engage a screw-driver into the slot in the end of the action lever
spindle and rotate clockwise until the slot is vertical. Hold this
position whilst fully tightening screw ‘A’. If the screw will not go
flush, re-align the spindle and try again.
