R O T A R Y
PAGE 18
4.5 ......Secondary Inking Position
There are two positions for the inking assembly as shown in
Fig.4.51. The Primary Position is preferred because it allows better
access into the machine.
Both positions work equally as well but with the following
exceptions:-
- If, after setting a numbering head, it stops below or just in front of
the ink transfer roller, you must change the inking to the
alternative position. Refer to Figs 4.52 & 4.53 to establish the
exact point at which the position will need to be changed.
Failure to move the inking will cause the transfer roller to be
damaged (when the head stops below the roller), or poor quality
inking (when the head stops just before the roller).
To change from Primary to Secondary Positions or vice versa,
remove all Ink Pods, (see section 4.2) push the assembly to the
desired position, and then replace the Ink Pods. (See section 4.3)
Section 4
INKING
Primary & Secondary Inking Positions ........................ Fig 4.51
PAPER DIRECTION
PRIMARY POSITION
SECONDARY POSITION
