Morgana Digifold Pro CB, Service Manual

Page: 28 / 92

CREASING / FOLDING Page 28
SECTION G
DIAGNOSTICS and CALIBRATION TOOLS.
SET THE TOTAL COUNT TO ZERO.
SET THE MEASUREMENT SYSTEM (METRIC / IMPERIAL SETTINGS).
SETTING THE VACUUM DRUM POSITION.
SETTING THE VACUUM DRUM SUCTION DELAY.
To enter the engineers tools menu.
Turn the Machine on.
Insert the Engineers Plug into the Socket located at the rear of the machine.
Select Tools on the Display and continue to select required tool.
To set the total counter to zero.
Turn the Machine on.
Insert the Engineers Plug into the Socket located at the rear of the machine.
Select Tools on the Display and select this button,
this value denotes the Machine total.
To set the measurement system for Imperial (Inch) or Metric (mm) the following procedure
Is necessary.
Turn the machine on.
Select Tools on the Display and select
‘METRIC or IMPERIAL’ by toggling the button. (white is ON)
To set the vacuum drum start position the following procedure Is necessary.
Turn the machine on.
Insert the Engineers Plug into the Socket located at the rear of the machine.
Select Tools on the Display and select ‘Vac Drum Trim’ by toggling the button.
Input a value and run, repeat until start position is correct under the papergate.
Return to the main screen and remove the engineers plug.
To set the vacuum drum suction start time the following procedure Is necessary.
Turn the machine on.
Insert the Engineers Plug into the Socket located at the rear of the machine.
Select Tools on the Display and select ‘Vac Suck Trim’ by toggling the button.
Input a value and run, repeat until start delay is correct.
Return to the main screen and remove the engineers plug.
Counter button