Morgana Digifold Pro CB, Service Manual

Page: 44 / 92

Page 44
2.6.
2.7.
2.8.
If adjustment is required, loosen the two outside M8 Cap Head Screws securing the
Upper Pivot Block to the Frame, the two inside M8 Cap Head Screws securing the
Lower Pivot Block to the top of the Blade Drive Stepper Motor Mounting Plate & the two
outside M8 Cap Head Screws securing the Lower Pivot Block to the Frame.
(See FIG.2.6 below).
Gently tap the Lower fixing screws in the appropriate direction until the lead edge of the
test sheet is parallel with the Tie Bars.
. Tighten all screws in the reverse order
when complete.
Do not
loosen the two inside or the two outside screws securing the bottom of the
Blade Drive Stepper Motor Mounting Plate.
Do not tap the Upper Pivot Block or its fixing
screws as this will twist the Dynacrease Unit - the Upper Pivot Block will self-
align providing its fixing screws are loose
It's important to note that the lay edge of the test sheet must be kept in
complete contact with the Fixed Side Lay (Manifold) during this process.
CREASING / FOLDING