Morgana Digifold Pro CB, Service Manual

Page: 16 / 92

Page 16 CREASING / FOLDING
SECTION C
REMOVAL/REPLACEMENT CREASING DRIVE BELT
1. With the creasing mechanism out of the machine you can work on the bench to
disassemble the unit.
8. The Belt can now be replaced.
Reassembly is the reverse procedure beware that
when tightening the top swinging block shoulder
screw, this should be held parallel to the power link.
This can be achieved by passing a 4mm allen
key through the sideplate slot and the power link slot.
2. Remove the Blade/Anvil Assembly
3. Unscrew the two countersunk head screws from the input and output guides and
remove them.
4. Remove the four tie bar securing nuts at the
drive end of the mechanism (Pulley end).
5. Using a 3.0 mm A/F allen key remove the two
shoulder bolts.
6. Remove the top swinging block along with
the M6 thin washer.
7. Tap the side plate from the assembly
and remove the belt.
The Belt must be tensioned so that it takes 0.5Kg
to push the belt until it just touches the tie bar.
This is carried out by adjusting the motor downwards
and is possible to do from the outside of the frame by
loosening the four M5
Belt Tightness
Bolts that locate the motor
within adjustment slots.