Moretti SKEMAFORM Rugy PM100X, Instruction Manual

Page: 45 / 76

21
ENGLISH
16.4 Technical specifications
Required force to operate the
controls on the remote control
5 N
Required force to push the
elevation pedal (MI39X)
30N
Input 100-240V AC 50/60Hz 145VA
Output 24 VDc
Protection Class IP 54
Noise level < 45 DB
Insulation Class 2 Class
Used materials for bed mainframe Varnished steel frame, foam bed cover in PVC
17. TROUBLE SHOOTING
SYMPTOMS POSSIBLE CAUSES SOLUTION
No command
working 1. The power plug is not connected
to the mains voltage socket
2. The remote control is not
connected to the control unit
3. Probable defect in the remote
control or control unit 1. Connect the power plug
2. Check and if necessary connect the
remote control to the control unit
3. Contact the service center for a
more precise diagnosis of the problem
Backrest, legrest
and trendelenburg
eletric movements
do not work 1. The backrest, legrest or
trendelenburg actuators are not
connected to the control unit
2. The actuator or remote control
or control unit may be faulty 1. Check and if necessary connect
the actuators to the control unit
2. Contact the service center for a
more precise diagnosis of the problem
The elevation of the
chair does not work 1. The elevation actuator is not is
connected to the control unit
2. The actuator or remote control
or control unit may be faulty 1. Check and if necessary connect
the actuator to the control unit
2. Contact the service center for a
more precise diagnosis of the problem
The electric foot
controls (pedals)
does not work 1. The foot control does not is
connected to the Y cable
2. Y cable is not connected
to the control unit
3. The electronic control unit and /
or the actuators may be defective 1. Check and if necessary connect
the foot control to the Y cable
2. Connect the Y-cable to the controller
3. Contact the service center for a
more precise diagnosis of the problem