16
English
Before Requesting Repairs or Service
WARNING
This product can be disassembled and repaired by qualified repair technicians only.
If you
fi
nd any problems, follow the troubleshooting procedures below.
Problem
Primary cause
Remedy
The power does not
turn on.
The power cord is not
•
plugged into the outlet.
Plug the power cord into the outlet.
•
No mist is formed,
or the amount of
mist is small.
The Power/Water indicator
•
(P/E) is lit red.
Fill with water.
•
Even if the Power button
*
is pressed immediately after
the Power/Water indicator (P/E)
turns off, the humidifier does
not produce mist for about two
minutes. This is because the
water temperature is heated to
at least 60°C for sterilization
before starting the misting
operation.
The ceramic disc must be
•
replaced.
Replace the ceramic disc (See page 14).
•
The Power/Water
indicator (P/E) is lit
red even though
water was
fi
lled.
The water tank is not
•
mounted to the humidifier
securely.
Load the water tank so that it fits
•
securely.
A smell is emitted.
Using water other than clean
•
water.
Drain the water left in the water tank
•
and water tub, and clean by following
the procedure in “Cleaning and
Storage”.
The mist nearly
stops once every
minute.
This is not a malfunction. To
•
prevent water from collecting
at the mist outlet, fan motor
stops operation about once
every minute, and the fan
stops for about two seconds.
This is normal operation, and it is not
•
a malfunction.
01̲MOD-KH1101EU.indb 16
01̲MOD-KH1101EU.indb 16
2014/07/11 21:51:17
2014/07/11 21:51:17
