16
17
www.DeubaXXL.de
www.DeubaXXL.de
16
17
www.deubaxxl.de
www.deubaxxl.de
2.
Secure the pulley with the support frame
on the transom. The support beam is in turn
requirements and is appropriate to the place
withstand the rated load.
3. The electric hoist uses a single-phase power
supply. The rated voltage is 230 V ± 5%, and the
rated frequency 50Hz ± 1%. The motor must be
reliably earthed and the power supply circuit
4.
the pulley up and down in jog mode. You
can operate the pulley up and down without
a load. Only test the pulley with a load when
the up and down movement is reliable and the
5.
you have to wait for it to cool before using it
again. You should avoid using the device too
frequently in jog mode when it is carrying a
load.
6. The ambient room temperature should be
between 5 - 40 ° C. and height above sea
level less than 1000m. The ambient humidity
should be between 30-95%. The temperature
IV. Safety Advice
The electric pulley should be maintained by
a specialist and users should pay heed to the
following:
1.
the pulley.
2.
3.
4. Before commissioning, you must carry out the
idle tests and check the following points:
•
and moves the hook up and down.
•
Check the limit switch works properly. The stop
•
Check to see if any unusual noises can be heard
•
make sure the brake disc is working properly. If
•
is deformed in any way. If it is, replace it
has been replaced.
•
If the steel cord is damaged as shown in the
•
Check regularly that the steel cable is in good
of the steek cable it must be replaced by a
professional.
5. Overloading the pulley is forbidden. It is also
devices.
6.
7.
weights over the maximum load.
8.
people to be standing under the device.
9. The maximum load is stated on the device’s
Important Pulley Data
Type
DBSW003
Nominal voltage
230V~
Nominal frequency
50Hz
Rated output
1050W
Nominal current
4.6A
Nominal Working Load
Single hook/Double
hook (KG)
300kg
600kg
Single hook / Double
hook
8m/min
4m/min
Single hook / Double
hook (m)
12m
6m
Steel cable diameter
(mm)
4.5mm
Steel cable tensile re-
sistance
1870 N/mm2
IP54
Safety class
A1
(8000 full load cycles)
Working system
ED: 20% 150s/h
Weight of the device
17.0kg
Noise level
71 dB(A)
is advisable for the safety of the user.
breaks for 8 minutes. A cycle lasts 10 minutes including the break.
1.
correct and whether the engine has been damaged by the rain or water. When rain and water damage
Work environment
temperature
5-35˚C